To get the longest life possible out of your TRUK eBike you can take some simple steps to maintain it yourself, without regular trips to the dealer. Here are some general cycle tips to help you along –

• Keep your TRUK eBike clean. If possible clean it after each ride with bike-specific cleaners.
• Don’t use a jet wash or alike as this can drive out grease lubricating the bearings, it will also compress water into the internals which in turn will corrode essential components.
• If using a high powered hose be careful to not jet water in too close to the hubs, bottom bracket, headset or anywhere else that is normally greased throughout.
• Some bike shine products can leave a layer of protection over the paintwork, helping keep your TRUK eBike looking like new for longer. Be careful not to get this stuff close to any braking surfaces though!
• Use a decent chain oil to keep the chain lubricated after cleaning, make sure it isn’t left dry. Wet lube in the winter and dry lube in the summer. (Wet lube stays wet, dry lube dries).
• You can lube the cables with light spray oil, preferably one that dries and leaves a PTFE layer. If using a lubricant that stays wet, on your next outing dust can stick to this causing more problems and can cause the cable to seize. (With PTFE it will dry but leave a lubricating layer).
• When the TRUK bike is not in use try to keep it in a dry place out of the elements.
• Keep the tyres properly inflated. This will prevent uneven tyre wear. It will also make your life easier as the bike will roll with less resistance. In turn, the motor is working less and the range is extended. This can make more of a difference than you may think. (Tyre pressures are always printed on the side of your tyre).